Skip to main content
GORDON in 2010, waiting on restoration by the Wooden Boat Guild of Tasmania.
Gordon
GORDON in 2010, waiting on restoration by the Wooden Boat Guild of Tasmania.
GORDON in 2010, waiting on restoration by the Wooden Boat Guild of Tasmania.
Reproduced courtesy the Wooden Boat Guild of Tasmania.

Gordon

Vessel numberHV000434
DimensionsVessel Dimensions: 4.6 m x 4.42 m x 1.44 m (15.09 ft x 14.5 ft x 4.72 ft)
DescriptionIt is not known exactly when GORDON was built, but the assumption is that it was built around the 1920s or 1930s. GORDON is 4.6m long and 1.44m wide, with seven planks per side. From what is currently known of the type this is relatively long, but it retains a standard beam dimension. It is planked in King Billy pine and framed up with celery top pine, a typical combination for timbers for the punts. A close view of the stem shows an uneven layout to the planking, which suggests it was built out of whatever was available with no time wasted toward trying to give it the appearance of a tradesman's job.

GORDON is understood to have been used by Forestry Department of Tasmania staff as means of transport on the Gordon River in south west Tasmania, and it was fitted with an outboard at that time. It is also thought to have been salvaged as an abandoned boat beside the Gordon River prior to 1980 when it was acquired by Laurie Harris. He kept the boat until 2010 when it was given to the Wooden Boat Guild of Tasmania, who plan to restore it so that it can be rowed again in company with the few other remaining piners’ punts.

The west coast piners' punt has a shape ideally suited to its purpose. The dinghy transported Huon pine workers with their supplies and tools from their camps on the shoreline. They are thought to have originated in Port Davey where the Huon pine industry was well established by the late 1800s. They had a snub or transom bow and the square ends were often referred to as forward and aft tucks. They were built with a lot of rocker or spring to the keel line and no skeg so they could turn quickly. They also had to negotiate rapids. Although they had a slack turn of the bilge, their width made them reasonably stable. The shape had an easy run to the strakes, which allowed quick planking of the hull. Two or even three people could row them at a good speed. GORDON's shape reflects all of these traditional qualities.

SignificanceGORDON is an example of the piners' punt dinghies that are unique to the south western region of Tasmania. It shows the typical shape and construction arrangement used by these craft that were used as a transport for the men who logged Huon pine along the rivers in the rugged south west of the state. The rough and uneven planking lineout is a clear indication of the 'no frills’ approach often taken in their construction, which was done as cheaply and expeditiously as possible.
Vessel Highlights
Fee
c 1920
PUNT as restored in 2009
1920 - 1930
RIAWE in the early morning mist in 2009
EA Jack
1912
SOLACE II under sail in 2008. The additional shelter is one of the few changes to its appearenc…
Mews Boatbuilders
1938
OLGA and the Grinning family in 1925
1923
VIGILANT early in 2008 at Hobart Tasmania .
Ray Kemp
1971
KRAIT restored for the 75th Anniversary event on 26th September 2018 at the ANMM wharves.
c 1934
QUESTING on its trial sail after being restored by Sydney Wooden Boats in 2015/16
Andrew Riddell
1949
MISTRAL IV has an elegant low sheer and long overhangs and is quite different from the cruising…
J J Savage
1932